Installation of an Air Conditioning System ductless minisplit ductless mini split
Installation of an Air Conditioning System ductless minisplit ductless mini split like mitsubishi sanyo To Order Unit go to : cgi.ebay.com
More Air Conditioning Information
- EBay expects to generate $1.5B via mobile in 2010 – Mobile Commerce Daily – Applications
- Sanyo VPC-FH1 SD/SDHC HD Camcorder – $380 After $10 Coupon | GadgetReview
- Mitsubishi RDT232WLM LCD Screen « CyberTheater
- Sanyo Xacti ICR-XRS120MF Sound Recorder « CyberTheater
- What To Look For In The Top Three Home Air Conditioning Systems « UK Prestige Blog Arena
Hey, thanks a lot. From Puerto Vallarta.
is really practice the way in which the purging pipe was very useful to me! thanks for your video, which also does not pull much refrigerant, otherwise much liquid is spilled by loosening the nuts!
the shorter the copper pipes the cooler the a/c
your supposed to shorten the lineset if it is too long and reduce the charge applicably. its bad for refrigerant flow to coil it up and stuff it behind the condensing unit. and before opening the service valves, the lineset should be evacuated so non condensible gasses do not enter the system once the pre-charged condensing unit is opened to the rest of the system
You do NOT tighten the nuts as much as possible, as if you over-tighten them you can strip it or damage the flare.
You should test for leaks before letting gas into the system
than you for this video and explain how install a minisplit from veracruz mexico
WOW! Thank you so much, the instructions were very Confusing. You made it so much easier!
the refrigerant flow coils up in the a/c unit!
Not profesional !!!!
You know what’s odd? There used to be a door in the interior, but, there’s no door in the exterior takes xD
you could have cut the extra pipings not rounding them behind the o/d unit. for better perfecormance.
this is very usefull specially for beginners like me!!!can some one tell me how to remove the exterior fan of the split type ac with out wasting the freon or is it the refrigerant coz i will be removing it asap..basic steps will be very much appreciated!!!tnx so much for any one who can help!!!
in my opinion rounding them is much easier and better, and in the same time u will make what we call an oil trap, because sometimes if the outdoor unit will be higher then the indoor unit the oil will go throw the pipes to the indoor unit from the compressor, so when u round the pipes the oil will be trapped in there.
thanx alot, that would be very helpful for beginners xD
@ry4n0007 who cares more repair work for me :)
Fucking cowboys, love the way he uses all the pipe coiled up behind the condensor….AH HELLO VAC PUMP!!!
How can he get up of the outside unit on it´s supports? and he did not use any vaccum pump
he probley got it up with help from the camra man. and you do not need to vaccum pump the lines. 5:43 thats what the 4 pumps are for. to flush the lines clean. i did simular with my 2 splits and they have been prefect for a few years now.
purging the spring valves 4 times replace the vacuum pump ? Wooooow this video just saved me equipment for my service man !!
and by the way… those Asian unit installation manual showed for years to do that with R22 unit… now we know why the ozone layer is damaged….